ASSEMBLY INSTRUCTIONS:
1. Insert the Frame Base first and ground it
2. Insert other corresponding parts using the correct constraints and offsets
3. TIP 1: After you insert each part, check to see if the assembly freely rotates
4. TIP 2: I find if you change the colour/material of the part, it's easy to differentiate them and "see" them moving.
5. Set an angle constraint between the flywheel and the crankshaft
6. Drive the complete assembly 1000 degrees and watch magic happen
7. Get instructor to sign off
1. Insert the Frame Base first and ground it
2. Insert other corresponding parts using the correct constraints and offsets
3. TIP 1: After you insert each part, check to see if the assembly freely rotates
4. TIP 2: I find if you change the colour/material of the part, it's easy to differentiate them and "see" them moving.
5. Set an angle constraint between the flywheel and the crankshaft
6. Drive the complete assembly 1000 degrees and watch magic happen
7. Get instructor to sign off